Use of fiber cutting knife

Action:Open plate, peel good fiber is placed in a V-shaped slot, according to the length required by the operator to determine the cutting length.

2 Press the plate fixed fiber.

(3) close the lid to ensure that the fiber end in a straight line.

4 put a knife to the back.

5,Press the button.

6. Open the cutter cover.

7 Carefully remove a piece of cut fiber to prevent damage to the fiber end face.Clean up cutting out fiber, do not damage the blade, for future use.Replacement blades and blade adjustment1 --- 16 cutting points are marked on the blade.When the cutter is not working, with an alcohol wipe the first plate and the blade edge (Do not use acetone or corrosive solvent cleaning plate)If you still can not cut, this cutting point can no longer use, need to change the cutting position.

Blade placement consists of three parts, still need to change the cutting point, according to the following order of operation.Adjust the blade (blade marked on a 0 to 16 cutting points)

Use and safe operationRead this manual carefully before use and keep this manual cutter.

KL-21B cutter, please note the following to prevent the machine performance by the damage.

Do not wet cutter.Do not put the cutter on a humid or dusty place.

Stored at room temperature in order to avoid the high temperature caused by the deformation.

Do crashing cutter.

Do not use acetone or corrosive solvent to clean up the pressure MDF.