Fiber Fusion Splicer common solutions to problems

1 switch on Optical Fiber Fusion Splicer is no bright screen, and open the windscreen and found the level of the electrode pedestal lighting does not shine.Solution:1> Check that the power socket is plugged in, if not good then re-plugged.2> Check the power fuse is broken, if broken, replace the spare fuse.

 (2) fiber can be reset to normal, the optical gap settings appear on the screen but stops moving, and the screen stops at "setting the gap."Solution:1> Press the "Reset" button to reset the system.2> Open the draft shield, respectively, open the left and right plate. Check the following order:3> Check for broken fiber.4> Check the fiber length is cut too short.5> Check the tank containing fiber and fiber matches. And the corresponding treatment.

3 fiber-optic welding machine on the bottom of the screen a "battery exhausted" and the buzzer sounds continuously.Solution:1> This phenomenon generally occurs when using a battery case, simply replace the power supply can be.2> Check the power fuse box is tightened.

4 optical fiber can carry out normal reset, the gap setting screen dimmed, no optical image, and the screen stops at "setting the gap."Solution:Check windscreen is in place or reed pressure is good contact.

5 fiber can carry out normal reset, the gap setting optical fiber continued backward movement, the screen displays "set space" and "reload fiber."Solution:May microscope eyepiece optical system caused by excessive deposition of dust on, wipe with a cotton swab stick horizontal and vertical two-way microscope eyepiece, with no significant dust eye observation, you can try.

6 automatic calibration fiber, a fiber direction of movement up and down constantly, screen stops at "calibration."Solution:1> Press the "Reset" button to reset the system.2> Check Y / Z direction of the two fiber end position error is less than 0.5 mm, if less than the following operations, or sent to the factory for repair.3> Check the bare fiber is clean, if not clean, then deal with it.4> V-tank clean of dust deposition.5> a small pressure head tapping with your fingers, to determine whether a small compact optical head, if not then the process of compaction. You can try again.

7 automatic work mode, press the "Auto" button can be automatically set clearance, for coarse, fine calibration, but the naked eye can be clearly observed on the monitor screen when the dislocation to begin connecting.
Solution:Check on the images to be connected fiber defects or dust, according to the actual weight of cotton ball moistened with rubbing alcohol or re-making optical fiber end.

8 Press "Heating" button, heating indicator light flashes while the buzzer goes off soon after.Solution:1> Fiber will automatically check the validity of the heater plugs into. If you do not plug or plugged in, plugged in, you can please.2> prolonged heating the heater thermal protection will be automatically cut off the heat, can wait some time before heating.

9 optical fiber can carry out normal reset, the gap begins to set display "set space", a period of time the screen shows "reloading fiber."Solution:1> Press the "Reset" button to reset the system.2> Open the draft shield, respectively, open the left and right plate. Check the following order:3> Check for broken fiber.4> Check the fiber length is cut short.5> Check the tank containing fiber and fiber matches. And the corresponding treatment.